$12.00 + PRIORITY or 1st CLASS SHIPPING
SELECT COLOR CHOICE
This 1/4" thick plate doesn't sit on top of the quick hitch casting. Its shape goes around it sitting back in the stud pockets. With the standard hex studs, the plate would extend beyond the casting surface between 1/8" & 3/16". In most cases, this will clear the attachment. In some cases it will not. If not, we offer an optional modified hex stud ( with a shorter hex portion) to allow the plate surface to fall behind the casting surface.
The plate has received either Gravely orange or a black Powder Coat Paint for a durable finish.
This is the same 2 Stud Reinforcement Retainer Plate used as a push plate with our quick hitch adapters.
The 4 Stud Reinforcement Retainer Plate may be used instead of the 2 Stud Reinforcement Retainer Plate in cases where multiple studs need supported, or, one or more of the upper studs need supported with use of one of our Cogan Valley Machine Exclusive Design Quick Hitch Adapters utilizing the push plate.
Thank you for your consideration.
SELECT COLOR CHOICE
The Back Story
While we were out to the Dave Antram's Gravely Swap Meet in September, '09 we were asked if we could solve a problem with the studs of the quick hitch. The "Gravely" design allowed one or more of the studs to bend under the forces developed by the attachment, such as a snow blower, that would rest against the tilt limit bushing on the stud. "Gravely's" solution to this problem was to put a plate across two studs after you slid the attachment (such as the snow blower) on the horn. This took away from the "quick hitch" concept because you had to unbolt the plate before you could remove the attachment again. Our mission was to design a plate to bridge across two of the studs behind the attachment, thus reinforcing the studs enough to curtail the bending problem and keeping the "quick hitch" concept. We believe we have met the challenge with this superb offering.Description for the Gravely Quick Hitch 2 Stud Reinforcement Retainer Plate
This 1/4" thick plate doesn't sit on top of the quick hitch casting. Its shape goes around it sitting back in the stud pockets. With the standard hex studs, the plate would extend beyond the casting surface between 1/8" & 3/16". In most cases, this will clear the attachment. In some cases it will not. If not, we offer an optional modified hex stud ( with a shorter hex portion) to allow the plate surface to fall behind the casting surface.
The plate has received either Gravely orange or a black Powder Coat Paint for a durable finish.
This is the same 2 Stud Reinforcement Retainer Plate used as a push plate with our quick hitch adapters.
The 4 Stud Reinforcement Retainer Plate may be used instead of the 2 Stud Reinforcement Retainer Plate in cases where multiple studs need supported, or, one or more of the upper studs need supported with use of one of our Cogan Valley Machine Exclusive Design Quick Hitch Adapters utilizing the push plate.
Thank you for your consideration.
No comments:
Post a Comment
Please offer your thought about what you see in our world. We would also appreciate any suggestions of other needed products for us to consider for manufacture. Thank you for visiting our world.